What if, What if -13 – Symbol Technologies LS 3603 User Manual

Page 21

Advertising
background image

1-13

User’s Guide

What If...

Nothing happens when you follow the operating
instructions?

You Should

•

Check the system power; is there a battery in the battery box?

•

Be sure the scanner is programmed for the terminal in use.

•

Make sure the scanner is programmed to read the type of bar code you

are scanning.

•

Check for loose cable connections.

•

Check the symbol to make sure it is not defaced.

•

Try scanning test symbols of the same code type.

Symbol is decoded, but not transmitted to the host
terminal?

You Should

•

Be sure the proper host type is selected (See Chapter 2).

•

Make sure the appropriate parameter set (RS-232, Wand, Synapse) is

selected.

Scanned data is incorrectly displayed on the terminal?

You Should

•

Make sure the system is programmed for the correct keyboard type.

•

Make sure the CAPS LOCK key is off.

•

Be sure the proper host is selected.

•

Be sure editing options (e.g. UPC-E to UPC-A Conversion) are properly

programmed.

Note:

If after performing these checks the symbol still
does not scan, contact your distributor or call the
Symbol Support Center. See

page 1-15

for the

telephone number.

Advertising