Symbol Technologies LS 3603 - Manual (Page 31)

2-3
Programming
Set Default Parameter 2-4
Host Interface Code 2-4
Code Types 2-4
Code Lengths 2-4
Code 39 Full ASCI 2-5
Decode Options
UPC-E/UPC-A Check Digit 2-5
Convert UPC-E to UPC-A 2-5
EAN Zero Extend 2-5
Transmit No Decode Message 2-5
UPC/EAN Supplemental 2-6
Code 39 Check Digit 2-6
ITF-14/EAN-13 Conversion 2-6
MSI/Plessey Check Digit 2-6
MSI/Plessey Check Digit Alg. 2-6
Buffer Code 39 2-7
Beep After Good Decode 2-7
CLSI Editing 2-7
NOTIS Editing 2-7
UPC/EAN Security Level 2-8
Codabar Decode Redundancy 2-8
UPC-E/UPC-A Preamble 2-9
Data Transmission Formats 2-9
Prefix/Suffix Values 2-9
Laser On Time-out 2-9
For a listing of corresponding bar codes, see page 3-1.
RS-232C Options
Baud Rate 2-10
Parity 2-10
Beep on BEL 2-10
Hardware Handshaking 2-10
Software Handshaking 2-13
Stop Bit Select 2-15
ASCII Data Format 2-15
Intercharacter Delay 2-15
Transmit Code ID Character 2-15
Transmit AIM ID Character 2-15
Power Mode 2-16
Scanstand/IntelliStand 2-16
Wand Emulator Options
Wand Bar Output 2-16
Variable Leading Margin 2-16
Convert All to Code 39 2-16