Sony CAV-M1000ES - Manual (Page 29)

Setting up the Keypad
29 US
Customizing the Keypad
Setting bass and treble
You can adjust bass and treble to optimize the acoustic
conditions in each zone.
1
Turn off the power.
2 Press and hold MUTING and PAGE simultaneously,
and then press POWER.
The LCD panel changes to the Bass and Treble setup
mode.
3 Press the corresponding SELECTION button to
adjust the bass and the treble.
4
Turn off the power when you have finished.
The settings are confirmed when the power is turned
off.
Notes
• All other buttons, other than VOLUME +, VOLUME –,
MUTING and POWER, are disabled while you are making
settings.
• You can adjust Bass and Treble between ± 14 dB in 2 dB
step.
Setting volume limits
You can customize the volume limits to protect speakers
from being over driven.
1
Turn off the power.
2 Press SOURCE and LOCK simultaneously, and then
press POWER.
The LCD panel changes to the Volume limitation
mode.
3 Press the corresponding SELECTION button to
adjust the maximum volume.
4
Turn off the power when you have finished.
The settings are confirmed when the power is turned
off.
Notes
• All other buttons, other than VOLUME +, VOLUME –,
MUTING, and POWER, are disabled while you are making
settings.
• You can adjust the volume limits between level 64 and level
74.
Adjusting LCD contrast
1 Turn off the power.
2
Press and hold PLAY and the SELECT button in the
left-upper simultaneously, and then press POWER.
The display window enters the contrast setting mode.
3 Press the corresponding SELECTION buttons to
adjust the LCD Contrast Value.
4
Turn off the power when you have finished.
The settings are confirmed when the power is turned
off.
Notes
• All buttons other than POWER are disabled while settings
are being made.
• You can adjust the LCD contrast between level 01 and level
32.
Adjusting brightness
You can make only a minor adjustment.
Set the brightness of the display window to the adequate
brightness level by inserting a flathead screwdriver into
the bright adjustment hole. See page 11 for the location of
the brightness adjustment hole.
Turning all the zones off from the Keypad
1
Press and hold POWER until the figure below
appears in the display window.
2 Press YES to turn off all of the zones.
Press No to cancel the operation.
All the zones turn off and the display window turns
off automatically.
SELECT button