Shark LIGHT & EASY S3250 11 - Manual (Page 7)

6 TOLL FREE: 1-800-798-7398 7 www.sharkclean.com
English
IMPORTANT: Your steam mop needs
water to make steam! Never use
your steam mop without water in the
tank.
Sweep or vacuum your floors prior
to cleaning with your
Light & Easy™
Steam Mop.
Visit www.sharkclean.com for other
great quick cleaning products to
complement your
Light & Easy™
Steam Mop, such as the Shark ®
Cordless Stick Vac.
Using Your Light & Easy™ Steam Mop
1 Pull and twist the quick release
cord holder to unwrap the power
cord completely. (
fig. 1) Plug into
a 120-volt electrical outlet. ( fig. 2)
The “ On” light will turn blue. If the
light does not turn on, reference the
troubleshooting section on page 12.
(
fig. 3)
2 Wait 30 seconds for the boiler to
heat the water. Pump the handle
a few times to prime the pump,
activate steam and moisten the
micro-fiber pad. (
fig. 4)
3 Mop with a forward and backward
motion to customize steam output
automatically. (
fig. 5)
When you use your steam mop for the
first time or if you have not used the unit
in awhile, it may take a minute or two
for the water to travel through the pump
and into the heater to create steam. Get
it started by pumping the handle a few
times. If you have waited a few minutes
and you still do not see any steam,
reference the troubleshooting section
on page 12.
If your Light & Easy ™ Steam
Mop stops steaming, it could
be out of water. Unplug the
power cord from the electrical
outlet and refill the water tank
at anytime. 1
fig. 1
fig. 4
fig. 5
fig. 2
fig. 3
S3250_instructions_100526.indd 6-7 10-05-27 9:58 AM