SINGER 14T957DC User Manual
Page 45
In order for the Cover Stitch Plate to sit properly, you must set the seam width
finger to the “R” position.
TIPS FOR TRIPLE COVER STITCH
• Be sure to follow the threading sequence outlined above.
• Make sure needles are set-up in positions C, D, and E for the Triple Cover
Stitch. This is very well illustrated in the manual on page 15.
• Be sure to disengage moveable upper knife.
• Be sure to disengage the upper looper.
• Always start sewing on fabric.
• Never sew off the fabric. To remove fabric from machine, stop with the
needles up. Turn the handwheel towards you until you hear three
“clicks”. One for every needle. Stop – turn handwheel back (away from
you) until the needles are at the highest position. Lift presser foot, place
thumb on stitches and pull fabric back and away from the foot. The fabric
should pull away easily.
• Always reset the tension dials by re-selecting the stitch after threading the
serger.