Sony HVR-A1N - Manual (Page 55)

55
Using the Menu
HVR-A1U/A1N 2-639-667-11(1)
EXEC
Touch [NEXT]  [EXEC-A] or [EXEC-
B] and the recording setting changes to
the registered one. Touch [BACK] to
register again or touch [END] to finish the
operation.
By touching [SET] on the [EXEC] screen,
you can select [TRANS TIME], [TRANS
CURVE] or [REC LINK], and you can use
the start timer.

TRANS TIME
Select transition time (2 to 15 seconds).
(The default setting is 4 seconds.)

TRANS CURVE
Select the transition curve. The transition
curve changes as follows.
*1: parameter level
*2: transition of time
LINEAR
Make the transition linearly.
� �
� �
 SOFT STOP
Make the transition slowly at the end.
� �
� �
SOFT TRANS
Make the transition slowly at the
beginning and end, and linearly in
between.
� �
� �

START TIMER
Set the timer to start the shot transition.
 OFF
The timer is not used.
5 sec
Start the shot transition after 5 seconds.
10 sec
Start the shot transition after 10 seconds.
20 sec
Start the shot transition after 20 seconds.

REC LINK
 OFF
Not change when the recording starts.
SHOT-A
Change to SHOT-A when recording starts.
SHOT-B
Change to SHOT-B when recording starts.
• You cannot select [SHOT TRANS] while
recording.
• If you register [SHOT TRANS], the [WHITE
BAL.] setting is also registered at the same
time.
• The recording angle varies during [SHOT
TRANS].
• Use the tripod because [STEADYSHOT] does
not function.
PictBridge PRINT
See page 75.