Sony WEGA KLV-30MR1 - Manual (Page 10)

10
Safety Information
LCD Screen
• Although the LCD screen is made with high-precision
technology and has effective pixels of 99.99% or
more, black dots may appear or bright points of light
(red, blue, or green) may appear constantly on the
LCD screen. This is a structural property of the LCD
panel and is not a malfunction.
• Do not expose the LCD screen surface to the sun.
Doing so may damage the screen surface.
• Do not push or scratch the front filter, or place objects
on top of this unit. The image may be uneven or the
LCD panel may be damaged.
• If this unit is used in a cold place, a smear may occur
in the picture or the picture may become dark.
This does not indicate a failure. These phenomena
improve as the temperature rises.
• Ghosting may occur when still pictures are displayed
continuously. It may disappear after a few moments.
• The screen and cabinet get warm when this unit is in
use. This is not a malfunction.
Mains lead and
display cable
If you damage the mains
lead or display cable, it
may result in fire or
electric shock.
• Do not pinch, bend, or
twist the cable
excessively. The core
lines may be bared or
cut, causing a short -
circuit which may in
fire or electric shock.
• Do not convert or damage the mains lead or
display cable.
• Do not put anything heavy on the mains lead or
display cable. Do not pull the mains lead or
display cable.
• Keep the mains lead or display cable away from
heat sources.
• Be sure to grasp the plug when disconnecting the
mains lead.
Refer to the operating instructions when
disconnecting the display cable. If the mains lead or
display cable is damaged, stop using it and ask your
dealer or Sony service centre to exchange it.
Fluorescent lamp
This unit uses a special fluorescent lamp as its light
source. If the screen image becomes dark, flickers, or
does not appear, the fluorescent lamp has run down and
should be replaced. For replacement, consult qualified
service personnel.
When not in use
For environmental
and safety reasons, it
is recommended that
the set is switched off
when not in use - not
left in standby mode.
Disconnect from the mains.
Cleaning the screen surface
The screen surface is finished with a special coating to
prevent strong light reflections. Be sure to observe the
following precautions to avoid damaging the finish.
•
To remove dust from the screen surface, wipe gently
with a soft cloth. If dust is persistent, wipe with a soft
cloth slightly moistened with a diluted mild detergent
solution. You can wash and repeatedly use the soft
cloth.
• Never use any type of abrasive pad, alkaline/acid
cleaner, scouring powder or strong solvent such as
alcohol, benzene or thinner.
Cable wiring
Take care not to catch your feet on the cables. It may
damage the unit.
Installation
Do not install optional components too close to the
display unit. Keep optional components at least 30
cm away from the display unit. If a VCR is installed
in front or at the right side of the display unit, the
picture may distort.
Cooling fan
This display unit uses a cooling fan to avoid overheating.
Note that the noise of the cooling fan may be heard from
the display unit, depending on where the display unit is
installed.
Heat
Do not touch the surface of the display unit. It
remains hot, even after the display unit has been
turned off for some time.