Sony WEGA KLV-30MR1 - Manual (Page 66)

66
Additional Information
Specifications
KLV-30MR1
Media Receiver Unit (MBT-MRL1)
Power Requirement: 220-240V AC; 50/60 Hz
Power Consumption: 30 W
Standby Power Consumption: 0.6 W
Dimensions (w x h x d):
Approx. 430 x 105 x 348 mm
Weight: Approx. 6 kg
Display Unit (LDM-3000)
Power Requirement: 220-240V AC; 50/60 Hz
Screen Size: 30inches
Approx. 76 cm measured diagonally
Display Resolution:
1280 dots (horizontal) x 768 lines
(vertical)
Power Consumption: 150W
Standby Power Consumption: 0.1W
Dimensions (w x h x d):
Approx. 971.2 x 594.4 x 229 mm
with stand
Approx. 971.2 x 524.3 x 93.4 mm
without stand
Weight: Approx. 20 kg
Approx. 27 kg (including stand)
Panel System:
LCD Display Panel
TV system:
Depending on your country selection:
B/G/H, D/K, L, I
Colour system:
PAL, SECAM
NTSC 3.58, 4.43 (only Video In)
Aerial:
75 ohm external terminal for VHF/UHF
Channel Coverage:
VHF: E2-E12
UHF: E21-E69
CATV: S1-S20
HYPER: S21-S41
D/K: R1-R12,
R21-R69
L: F2-F10, B-Q, F21-F69
I: UHF B21-B69
Rear Terminals:
1/
21-pin Scart connector (CENELEC standard)
including audio/video input, RGB input, TV
audio/video output.
2/
21-pin Scart connector (CENELEC standard)
including audio/video input, RGB input, TV
audio/video output.
3/ (SMARTLINK; selectable)
21-pin Scart connector (CENELEC standard)
including audio/video input, S video input,
selectable audio/video output and Smartlink
interface.
4/ (SMARTLINK; selectable)
21-pin Scart connector (CENELEC
standard) including audio/video input, RGB
input, selectable audio/video output, and
Smartlink interface.
5
Y: 1 Vp-p, 75 ohms, 0.3V negative sync
P
B : 0.7 Vp-p, 75 ohms
P R : 0.7 Vp-p, 75 ohms
5
audio input (phono jacks)
500 m Vrms (100% modulation),
Impedance: 47 kilo ohms
5 SUB WOOFER: phono jack
: audio outputs (Left/Right) - phono jacks
5 CENTRE SPEAKER IN:
15W x 2 (4-ohms)
CTRL S: minijack
AV MOUSE: minijack
S