Sony CMT-GPX9DAB - Manual (Page 29)

T
rou
b
les
hooti
n
g
29 GB
“TUNED” does not appear in the display
(DAB only).
• Check all aerial connections, then press TAPE x
and TUNING MODE on the unit simultaneously
to perform the DAB Automatic Scan.
• The current DAB service is not available. Press +
or – (or TUNING + or – on the unit) to select a
different service.
• If you have moved to another area, some services/
frequencies may have changed and you may not
be able to tune into your usual broadcast.
Perform the DAB Automatic Scan procedure to
re-register the contents of broadcasts.
(Performing this procedure clears all previously
stored presets.)
“NO SERV” is displayed (DAB only).
• Check all aerial connections, then press TAPE x
and TUNING MODE on the unit simultaneously
to perform the DAB Automatic Scan.
“SCANNING” does not disappear.
• Depending on the DAB services available in your
area, scanning may take a few minutes.
Tape deck
The tape does not record or play, or there is a
decrease in sound level.
• The heads are dirty. Clean them (page 32).
• The record/playback heads are magnetized.
Demagnetize them (page 32).
The tape does not erase completely.
• The record/playback heads are magnetized.
Demagnetize them (page 32).
There is excessive wow or flutter, or the sound
drops out.
• The capstans in the tape deck are dirty. Clean
them (page 32).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetized.
Demagnetize them (page 32).
The tape does not record.
• No cassette is loaded. Load a cassette.
• The tab has been removed from the cassette.
Cover the broken tab with adhesive tape
(page 32).
• The tape has wound to the end.
Optional components
There is no sound.
• Refer to General item “There is no sound.”
(page 27) and check the condition of the system.
• Connect the component properly (page 25) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
The sound is distorted.
• Set the volume of the connected component
lower.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Disconnect the mains lead.
2
Reconnect the mains lead.
3
Press ?/1 to turn on the system.
4
Press CD x, DSGX and ?/1.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.