Sony RM-VL1000 - Manual (Page 55)

55
Continued
Notes
• When using the timer setting on this
Commander, only one setting can be
assigned to one program. If you want
to set the timer to turn on at a
programmed time, and to set the
timer to turn off at another time,
program the two settings separately.
• If there are some programs set to be
executed at the same time, they start
in order from the lowest program
number.
• According to the status of the
component operated by the timer
program, the next program might not
function successfully. When setting a
timer program, check carefully the
setting of other programs.
• Some programs cannot be executed at
the set time because the execution
time of the remote control output is
different depending on the contents
of the timer execution. Or, if the
execution time arrives while the
previous timer program is outputted,
the timer program begins after the
execution of the previous one. In this
case also, the program cannot be
executed at the set time. So, set the
timer regarding the contents and the
duration of the timer execution.
12
Repeat Steps 10 and 11.
When 32 steps are input, the
Macro step programming
registered with a beep sound.
Then the display returns to
step 6.
Notes
• You can input up to 32 steps for one
timer program number.
• A System Macro can be input as a
step.
• You can change the interval between
operation steps (page 42).
• The step of the TIMER button has an
interval of 250ms. This operation of
programming an interval is counted
also as a step.
• The SCROLL button is not counted as
a step.
13
When you have
programmed a series of
Timer Macro setting, press
the SET button.
With a beep sound, a series of
Timer Macro settings are
registered.
The display returns to Step 6.
Each time you press the SET
button, the display returns to
the previous one.
If you want to check the
execution of the timer
setting or set the timer
program to the standby
mode
See page 58.