Sony WEGA KZ 42TS1 - Manual (Page 12)

12
(US)
Installing and Connecting the TV
HD VD
IN
OUT
P B /B Y/G P R /R L R AUDIO
L R
VHF/UHF
AC IN
AUDIO OUT
COMPONENT VIDEO IN 2 / RGB IN
SUB
WOOFER
CONTROL
S
VIDEO L R AUDIO P B Y P R L R AUDIO S VIDEO
VIDEO IN 1 COMPONENT VIDEO IN 1
VIDEO IN 2
Connecting a DVD Player with Component Video
Connectors
This is the preferred hookup to use if:
• Your DVD player has component (Y, B-Y, R-Y) jacks.
Disconnect all power sources before making any connections.
1
Using three separate component video cables, connect the DVD player’s
Y, B-Y and R-Y jacks to the Y, P
B
and P
R
jacks on the TV. Use the
COMPONENT VIDEO IN 1 connections.
Tip
The Y, B-Y and R-Y jacks on your DVD player are sometimes labeled Y, C
B
and C
R
, or
Y, P
B
and P
R
. If so, connect the cables to like colors.
2
Using an AUDIO cable, connect the DVD player’s AUDIO OUT jacks to
the TV’s AUDIO IN jacks. Be sure to use the same row of inputs that
you used for the video connection (COMPONENT VIDEO IN 1 or 2).
Tips
• To take advantage of the Wide Screen Modes, set the TV’s aspect ratio to 16:9 on your
DVD player. For details, refer to the operating instructions supplied with your DVD player.
• Some DVD players are equipped with the three component video connectors; Y-Green, P
B
(C
B
, C
b
or B-Y) -Blue and P
B
(C
R
, C
r
or R-Y) -Red.
VMC-10HG (not supplied)
AUDIO-L (white)
AUDIO-R (red)
DVD player
RK-74A (not supplied)
Rear of TV
P
R
P
B
Y