Sony WALKMAN MZ-NH1 - Manual (Page 56)

56
The buttons and control used for
character input and their functions are
listed below.
5
Repeat step 3 and 4 enter all
characters of the label title.
6
Press the jog dial for 2 seconds or
more.
When the recording is stopped or the recording
moves on to the next track while labeling titles
during recording, the input at that point is
entered automatically.
You can change the track name, artist
name, album name, group name, or disc
name by doing the procedure for
“Labeling” (page 55).
To re-label a track name, artist
name, or album name:
Start playing the track you want to re-
label, and then change the track name,
artist name, or album name while the
recorder is playing, or while the recorder
is stopped and the track to be re-labeled is
currently selected.
To re-label a disc:
You can re-label the disc while the
recorder is stopped, recording, or playing.
• The recorder is able to display, but cannot
label using Japanese “Katakana” characters.
• The recorder cannot rewrite a disc or track
name of more than 200 letters that was created
by another device (in MD mode only).
Functions Operation 1)
1) Functions of the buttons or the controls may
differ depending on when the cursor is in the
letter input area or in the character palette.
To move the cursor to the
left or right in the letter
input area. Slide the jog lever
(., >).
To select a letter in the
letter input area. Turn the jog dial.
To enter a letter. Press the jog dial
or the jog lever
(NX • ENTER).
To enter a title. Press the jog dial
or the jog lever
for 2 seconds or
more (NX •
ENTER).
To switch between capital
letters, small letters, and
numbers/marks. Press P-MODE •
REPEAT.
To insert a blank space. Press VOL +.
To delete a letter. Press VOL –.
To cancel labeling. Press x for 2
seconds or more.
To move the cursor to
the right or left in the
character palette. Slide the jog
lever
(.,
>) .
To move the cursor up
and down in the
character palette. Turn the jog dial.
To move the cursor from
the letter input area to
the character palette. Press DISPLAY
• BACKLIGHT.
To move the cursor from
the character palette to
the letter input area. Press x or
DISPLAY •
BACKLIGHT.
To display “_ (space)”,
“:”, “/”, or “–” at the
input position in the
letter input area. Press SOUND •
SOUND SET.
To switch between capital
letters and small letters. Press SOUND •
SOUND SET.
Note
Re-labeling
Notes