Sony WALKMAN MZ-NH1 - Manual (Page 83)

83
Playback sound skips. • The recorder is placed where it receives continuous vibration.
, Put the recorder on a stable place.
• A very short track may cause sound to skip.
, Try not to create a short track.
Sound has a lot of
static. • Strong magnetism from a television or such device is interfering
with operation.
, Move the recorder away from the source of strong magnetism.
The volume of the
recorded track is low. • The track was recorded in analog mode (in digital mode, the
recording level is automatically set to the same level as that of the
sound source). Or you used a connecting cord with an attenuator.
, Use a correct connecting cord without an attenuator.
• The recording level was low.
, Adjust the recording level manually while recording (page 38).
Volume cannot be
turned up. • AVLS is on.
, Release AVLS settings (page 66).
No sound comes
through the
headphones/earphones. • The headphones/earphones plug is not firmly connected.
, Plug in the plug of the headphones/earphones firmly to the
remote control. Plug in the plug of the remote control firmly to
i
/LINE OUT.
• The plug is dirty.
, Clean the plug.
Virtual Surround or 6-
Band Equalizer does
not function or noise is
heard. • The “Audio Out” parameter is set to “Line Out”.
, Set to “Headphone” (page 51).
The volume from
connected speaker or
amplifier is low (when
analog connection) • The “Audio Out” parameter is set to “Headphone”.
, Set to “Line Out” (page 51).
The volume from the
headphones/earphones
is too loud. • The “Audio Out” parameter is set to “Line Out”.
, Set to “Headphone” (page 51).
The disc cannot be
played on another
component • The component does not support Hi-MD.
, Discs used in Hi-MD mode can be played only on components
that supports Hi-MD.
The recorder skips to
the next or previous
group (or skips several
tracks ahead or behind)
when you press the 5-
way control key
towards . or >. • You pressed GROUP before pressing the 5-way control key
towards . or >.
, The recorder returns to normal if no operation is made for 5
seconds.
The edited tracks may
exhibit sound dropout
during search
operations. • This occurs due to the MiniDisc system limitation. The
fragmentation of data may cause sound dropout while searching
because the tracks are played in higher speed than normal
playback.
Symptom Cause/Remedy