While using group function, While the recorder is connected to the computer – Sony WALKMAN MZ-NH1 User Manual

Page 85

Advertising
background image

85

While using group function

Symptom

Cause/Remedy

The group function does
not operate.

• While using a disc without group setting, an attempt was made to

select some group-related menu.
, Use a disc with group setting.

A track cannot be
recorded to a new group.
A new group cannot be
created.

• This is due to the MiniDisc system limitations (in MD mode

only). Group information has been written to the area where the
disc name is stored. The disc name and track names are recorded
in the same area, which can store a maximum of approximately
1,700 characters. If the total number exceeds this amount, a new
group cannot be created even though group mode is on. It is also
impossible to make group settings at this time.

While the recorder is connected to the computer

Symptom

Cause/Remedy

The recorder is not
recognized by the
computer.

• The dedicated USB cable is not firmly connected.

, Connect the dedicated USB cable firmly to the recorder and

the computer.

• A USB hub is used.

, Connect the dedicated USB cable directly to the USB port of

the computer.

• Network communication has failed.

, Disconnect the dedicated USB cable, wait at least 2 seconds,

and then reconnect it. If the recorder is still not recognized,
disconnect the dedicated USB cable, restart the computer, and
then connect the dedicated USB cable again.

Even though the recorder
is recognized by the
computer, it does not
operate normally.

• A USB hub is used.

, Connect the dedicated USB cable directly to the USB port of

the computer.

• You are using the recorder at a place with vibration.

, Use the recorder at a place with no vibration.

The recorder cannot be
used as a storage device.

• The SonicStage or MD Simple Burner software is active.

, Close the SonicStage or MD Simple Burner software.

• A standard disc is inserted.

, Insert a disc used in Hi-MD mode. Only discs used in Hi-MD

mode can be used as a storage media.

The playing time of a
transferred track is
different from the time
that appears on your
computer monitor.

This is due to a calculation discrepancy between the recorder and
the computer.

Advertising