Specialized Elite CylcoComputer User Manual
Page 2
MOUNTING
THE SPEEDZONE
®
ELITE
The SpeedZone
®
Elite wireless transmit-
ter can mount on the right or the left
side of the fork blade. The right side
should be used on large frames or
when a suspension fork is installed.
The optimal distance between the com-
puter and the transmitter is 24 inches
(610mm) The distance may need to be
less than 24 inches (610mm) if ambi-
ent temperatures are below 40°F (4°C).
To reduce signal loss in colder temper-
atures, the transmitter should be
mounted as close to the computer as
possible. (Maximum mounting distance
is 28 inches). Use the transmitter-
mounting bracket and tie-wraps pro-
vided to position the sensor. Do not
tighten the tie-wraps until final place-
ment of the magnet is correct.
(See figure 1).
Attach the magnet to a spoke across
from the transmitter with the magnet
screw. The clearance between the
magnet and the transmitter should be
approximately 1/32"-1/16" (1-2mm).
3
This computer also features:
• Second Wheel Option
• Easy Calibration Mode
• Wireless Mounting System
• Heavy-duty abrasion resistant
pick-up wire
• Water resistant housing
• 2 Year Warranty
• Backlit LCD display
What is included in your
SpeedZone Elite package:
1. SpeedZone
®
computer (1)
2. Mounting bracket wired for cadence (1)
3. Mounting bracket w/out cadence wiring (1)
4. Magnet with screw (1)
5. Cadence magnet (1)
6. Cable tie wraps (8)
7. Mounting bracket sizing straps (3)
8. Transmitter (1)
9. Transmitter mounting bracket (1)
2
1
2
3
4
6
5
7
8
9
500-700mm
20-28 in.
FIGURE 1:
SENSOR
PLACEMENT
FIGURE 2:
MAGNET
ATTACHMENT
01_SDZN_ELITE_USA_1-22.qxd 4/18/01 8:32 PM Page 2