Specialized Elite CylcoComputer - Manual (Page 3)

sensor wire along the head tube, down
tube and chain stay of your bicycle
and secure it into place using the
provided tie-wraps. (See figure 4)
Next, attach the cadence magnet to
the inside of your crank arm directly
across from the sensor. Use a tie-wrap
to fasten the magnet to the crank arm.
(See figure 5).
Do not tighten the tie-wrap until final
placement of the magnet is correct. The
clearance between the magnet and the
sensor should be approximately
1/32"-1/16" (1-2mm). (See figure 6)
Tighten the magnet and sensor.
5
Tighten the magnet and transmitter. Do
not over-tighten the magnet screw.
(See figure 2).
Attach the mount to the handlebar
using the bracket screw provided.
Tighten so that the bracket cannot
rotate on the handlebar. There are sev-
eral sizing straps provided to fit differ-
ent diameter bars. (See figure 3).
Slide the computer forward onto the
mount until it ‘snaps’ into place with an
audible click. To remove the computer,
push it backward until it releases from
the mount. To test for proper installa-
tion of the magnet, transmitter and
computer, activate the computer by
pushing the ‘MODE’ (right side) but-
ton. Pick up the front of the bicycle and
spin the front wheel. The "wheel
option" indicator will flash. If it does
not flash, check the sensor and magnet
alignment. Realign as necessary until
the "wheel option" indicator flashes
while spinning the wheel.
MOUNTING CADENCE HARDWARE
In order to use the cadence option you
must install the mounting bracket with
the wired sensor provided with your
SpeedZone
® Elite. Run the cadence
4
FIGURE 4:
CADENCE WIRE PLACMENT
FIGURE 5:
CADENCE SENSOR
PLACEMENT FIGURE 6:
CADENCE MAGNET
ATTACHMENT
FIGURE 3: MOUNTING BRACKET
01_SDZN_ELITE_USA_1-22.qxd 4/18/01 8:32 PM Page 4