Sanyo VCC-ZM400 - Manual (Page 48)

VIEW SETTING
Slow shutter speed (LONG) mode setting
1 Use the cursor button (j or l) to move the cursor to
SHUTTER, then use the cursor button (d or c) to select
the speed mode for the electronic shutter. (e.g. LONG)
Then press the SET button.
The ES SETTING screen will appear and x1 (1/60 sec) will be
blinking. This setting is suitable for dark target objects.
Note: When setting the electronic shutter, the ELS button on the
system controller can only be used to turn the electronic
shutter on and off.
2 Use the cursor button (d or c) to select a electronic
shutter speed.
Available settings: x1, x2, x4, x8, x16, x32 (Field times
shown as multiples.)
☞ To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
Note:
SHUTTER (LONG) cannot be set if any of the following settings is
active.
• MOTION: ON
• IRIS: AUTO item SENSE UP (activated) or MANU item El
(ON)
1 2
ES SETTING
SHUTTER SPEED x1
PRESET OFF
MENU BACK
VIEW SETTING 1
IRIS MANU ‚
WHITE BALANCE ATW ‚
SHUTTER LONG ‚
MOTION OFF
APERTURE ON ‚
GAMMA ON
PRESET OFF
MENU BACK
L5AD2/US (VCC-ZM400) GB 2003, 2, 4
En
g
lis
h
47