Sanyo VCC-ZM400 - Manual (Page 59)

OPTION SETTING
4
POLARITY setting
Use the cursor button (j or l) to move the cursor to
POLARITY, then use the cursor button (d or c) to select
“NO” or “NC”.
Available settings:
• NO: Normal open (Normally open so closed condition is
detected as input.)
• NC: Normal closed (Normally closed so open condition is
detected as input.)
5
Motion sensor input setting (MOTION)
Use the cursor button (j or l) to move the cursor to
MOTION, then use the cursor button (d or c) to select
the input.
Matches information from the camera’s motion sensor and
the external alarm and outputs it.
Available settings:
• OFF: Does not output a motion sensor alarm.
• AND: Outputs an alarm when an external alarm input and
motion sensor alarm are detected at the same time.
1 External alarm input
2 Motion sensor detection
• OR: Outputs an alarm if either an external alarm or a
motion sensor alarm is detected.
6
Alarm duration setting (DURATION)
Use the cursor button (j or l) to move the cursor to
DURATION, then use the cursor button (d or c) to
select the alarm duration.
Set the duration for the following alarm input reception.
Available settings: 5S (default setting), 10S, 15S, 20S, 30S,
1M, 2M, 3M, 4M, 5M
☞ To close the menu screen or return to the previous
screen, select BACK or END for MENU and press the SET
button.
3, 4
ALARM SETTING
ALARM IN ALM
POLARITY NO
MOTION OFF
DURATION 5S
ALARM OUT OFF
POLARITY NO
ALARM TIME 5S
LINE OUT OFF
1
DURATION
ALARM OUT
ALARM TIME
2
L5AD2/US (VCC-ZM400) GB 2003, 2, 4
Eng
lish
58