Sony 3-877-030-12(1) - Manual (Page 9)

9 GB
Gettin
g
Sta
rted
Preventing the TV from
toppling over
As a protective measure, secure the TV.
Perform following steps as a protective measure
if you have a Sony LCD TV.
1
Place the TV on the center of the stand.
2
Fasten the support belt (supplied) to
the stand with the small screw
(supplied).
Tighten the screw into the rear hole, as in the
illustration.
3
Fit the support belt to the TV, then
firmly fasten with the large screw
(supplied) using a screw driver or coin,
etc.
4
While supporting the TV, tighten the
support belt to secure in place.
Installing the shelf board
1
Insert the attaching shelf support pins
(supplied) into the holes in the stand.
2
Fit the shelf board onto the shelf
support pins horizontally. This requires
people.
Installing this stand
Install the stand after connecting all the
components to the stand.
Install the stand, allowing for at least 10 cm
space between the wall and the rear of the stand,
and 30 cm between the wall and the left side of
the stand. This is to allow for heat dissipation and
to prevent the TV from falling.
• Be careful not to pinch your fingers when setting up
the stand.
Setting this stand
(large)
(small)
Note
At least
10 cm
At
least
30 cm