Sharp KB-4425J - Manual (Page 30)

30
OVEN COOKING
HOW TO SET OVEN TEMPERATURE FOR BAKE
SET TEMP
1 Touch Bake pad. 2 Touch number pads or pre-set pads for
desired temperature.
3 Touch START pad. When the oven
reaches the programmed temperature, a
signal will sound.
TO CHANGE SET TEMPERATURE DURING PREHEATING OR AFTER OVEN IS PREHEATED:
1 Follow the steps 1-3 above.
4 During preheating, the Temp pad will appear in the lower right-hand corner of the touchscreen. Touch this
pad to do the following:
• Temp x 1: Check the set temperature.
• Temp x 2: Change the set temperature. When you see 000
o in the lower left-hand corner of the touchscreen,
use the number pads to change the temperature, then touch START.
• Temp x 3: Display shows the actual temperature during preheating. It will read “Temp Lo F” until the
oven reaches 90 o F.
Once the oven is preheated, the Temp pad will remain in the display. By touching it once, you can change the
set temperature using the number pads. Then touch START. If you touch it a second time, it will once again
show the set temperature.
HOW TO PROOF
The Insight Range has an automatic setting for proofing bread dough at 100 o F. You can access the “Proof” pad by touching
the Bake pad. The oven temperature can also be set manually for 90-100 o F for proofing bread dough. If you have just finished
using the oven and the residual temperature is 105˚F or higher, when you enter 90-100˚F or select Proof and touch the START
pad, the oven will display “OVEN TOO HOT”. The oven will not start until it cools below 105˚F, a safe temperature for yeast.
When the oven cools, the oven display will change to “Touch START”. Simply touch the START pad and the oven will maintain
90-100˚F for proofing.
Convection
Bake
Broil
Reheat
Defrost
Micro Cook
2:40 PM DEC 22