Racks, Light replacement, Back cover – Sharp KB-4425J User Manual

Page 44: Cleaning and care

Advertising
background image

44

CLEANING AND CARE

OVEN RACKS

Clean with soap and water, rinse and polish dry.
To remove stubborn soil, use an abrasive cleanser or steel

wool. After cleaning, rinse the racks with clean water and

dry with a clean cloth.
Note:
• If the racks become hard to slide, apply a small amount

of cooking oil to a paper towel and wipe on the edges of

the oven racks.

• Do not leave in oven during self-cleaning cycle.

BROILER PAN, GRID AND

ROAST/BROIL RACK

Remove from oven at end of roasting or broiling. Drain

away fats and accumulated juices. Sprinkle the grid with

detergent and cover with wet paper towels or wet dish cloth.

Allow to cool.
Wash in hot soapy water and scrub any remaining food

particles with a soap filled pad or plastic scouring pad. Rinse

and polish dry with a soft cloth.
The broiler pan, grid and roast/broil rack can be washed in

the dishwasher.
Note:
• Do not leave in oven during self cleaning cycle.

OVEN LIGHT REPLACEMENT

CAUTION

Be sure the oven is unplugged and all parts are

COOL before replacing the oven lightbulb. Do not turn

the oven light on during the self-cleaning cycle. The high

temperature will reduce lamp life.
The interior oven light will turn on automatically when the

oven door is opened.
The oven light may be turned on when the door is closed by

using the oven light switch located on the control panel.
The bulb is covered with a glass shield held in place by a

wire holder.

This glass shield must be in place whenever the oven is

in use.

TO REPLACE THE LIGHT BULB

1 Turn the power off at the main source.
2 Wear a glove with leather palm for protection against

possible broken glass.
3 Replace bulb with a 40 watt appliance bulb only.
4 Press wire holder to one side to release glass shield. Replace

glass shield.

Advertising
This manual is related to the following products: