SanDisk UM809 - Manual (Page 38)

Tips & Troubleshooting
35
ACTIVITIES AND SHALL NOT BE LIABLE FOR ANY LIABILITIES OR DAMAGES ARISING FROM
SUCH USE.
8. General. This Agreement contains the entire understanding between the parties with
respect to your use of the Software. If any part of this Agreement is found void and
unenforceable, it will not affect the validity of the balance of this Agreement, which shall
remain valid and enforceable according to its terms. This Agreement is governed by and
construed under the laws of the State of California and controlling U.S. federal law without
regard to conflicts of laws provisions thereof. The U.N. Convention on Contracts for the
International Sale of Goods shall not apply to this Agreement. Any action or proceeding
arising from or relating to this Agreement shall be adjudicated in the state or federal courts
of Santa Clara County, California, and the parties hereby agree to the exclusive jurisdiction
and venue of such courts. You will not remove or export from the United States or re-export
from anywhere any part of the Software or any direct product thereof to any country in
violation of U.S. Export Administration Regulations, or a successor thereto, except in
compliance with and with all licenses and approvals required under applicable export laws
and regulations including, without limitation, those of the U.S. Department of Commerce.
Any waivers or amendments of this Agreement shall be effective only if made in writing and
signed by an authorized representative of each party. You agree that the Licensors are third
party beneficiaries of this Agreement to enforce your performance of the terms and
conditions of this Agreement. The provisions of Sections 2, 3, 4, 5, 6, 7, 8 and 9 shall
survive the termination or expiration of this Agreement.
FCC Regulation
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be determined
by turning the equipment off and then on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Increase the separation between the equipment and receiver.
2. Correct the equipment to a different outlet so that the equipment and receiver are on
different branch circuits.
3. Consult the dealer or an experienced radio / TV technician for help.