Sharp XL-3000V - Manual (Page 7)

– 7 –
XL-3000V
Note:
If the TV/monitor does not have a video input, the VIDEO OUT
socket on the unit should be connected to a VCR with a video input,
which in turn should be connected to the TV/monitor through the TV
ANTENNA/CABLE input. (Be sure to turn on the VCR, and set the
VCR's input mode to "auxiliary".)
■ TV/monitor connection
If the TV/monitor has a video input, connect it to VIDEO OUT socket
on the rear of the unit.
System Connections (continued)
■ Placing the speaker system
There is no distinction between the right and the left speakers.
Left speaker Right speaker
Speaker grilles are removable:
Make sure nothing comes into contact
with the speaker diaphragms when you
remove the speaker grilles.
Notes:
● The speakers are magnetically shielded.
Therefore, they do not affect the display even you use them near
the TV. However, some colour variation may occur, depending on
the type of TV used.
If colour variation occurs...
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present...
Move the speakers further away from the TV.
● If any kind of magnet or an electromagnet is placed too close to
the TV and the system, irregular colours may appear on the TV
screen.
TV
To video
input socket
Video cable
System Connections
Right speaker
Left speaker
FM aerial
AM loop aerial
MD recorder
not supplied
TV
Right speaker Left speaker
Black wire
Black wire
with white dots
To a wall socket