Sharp XL-3000V - Manual (Page 9)

– 9 –
XL-3000V
3
Press the (OPEN/CLOSE) button to open the disc
compartment.
t
Listening to a CD
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "CD" or "NO DISC"
appears on the display.
When operating with the remote control, press the CD button.
4
Place a CD on the spindle, label side up.
Be sure to place 8 cm (3") disc in the middle of a disc holder.
5
Press the (OPEN/
CLOSE) button to
close the disc com-
partment.
Total number of
racks
Total playing time
6
Press the ( ) button to start playback from track 1.
When the last track on the disc has finished playing, the unit will
stop automatically.
To interrupt playback:
Main unit operation:
Press the
button.
To resume playback from the same point, press the button again.
Remote control operation:
Press the button.
To resume playback from the same point, press the button.
To stop playback:
Press the button.
To remove the CD:
Whilst in the stop mode, press the (OPEN/CLOSE) button.
Press the disc eject button and remove the CD.
Listening to the Radio
To receive an FM stereo transmission:
Press the FUNCTION (BAND) button to display the "ST" indicator.
● " " will appear when an FM broadcast is in stereo.
● If the FM reception is weak, press the FUNCTION (BAND) button
to extinguish the "ST" indicator. The reception changes to mon-
aural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "FM" or "AM" ap-
pears on the display.
When operating with the remote control, press the TUNER but-
ton, and then the BAND button to select "FM" or "AM".
3
Press the TUNING ( or ) button to tune in to the de-
sired station.
Manual tuning:
Press the TUNING button as many times as required to tune in
to the desired station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 sec-
onds, scanning will start automatically and the tuner will stop at
the first receivable broadcast station.
Notes:
● This can be operated by pressing the TUN. ( or ) button
on the remote control.
● When radio interference occurs, auto scan tuning may stop
automatically at that point.
● Auto scan tuning will skip weak signal stations.
● To stop the auto tuning, press the TUNING button again.
FM stereo mode indicator
FM stereo receiving indicator