Continued), Md recording and playback, Radio reception – Sharp MD-M3H User Manual

Page 48: Remote control cd playback

Advertising
background image

46

(Continued)

Symptom

A recording cannot be made.

Even though a disc has been
loaded, “MD NO DISC” or “READ
ERR” is displayed.

Playback sounds are skipped.

Possible cause

Is the MiniDisc protected against
accidental erasure?

Did you try to make recording on a
play-back only MiniDisc?

Can you see the “DISC FULL” or

“TOC FULL

” message in the dis-

play?

(

:number or symbol)

The disc is very dirty.

Is the unit located near excessive

vibrations?

Has condensation formed inside the

unit?

Remedy

Slide the accidental erase pre-
vention tab back to its original
position.

Replace it with a recordable
disc.

Put in another recordable disc

with recording space on it.

Clean the disc.

Place the unit on a firm, level

surface free from vibration.

Remove the disc and leave the

power tur ned on. The unit
should function properly in
about 1 hour.

MD recording and playback

Symptom

Radios make unusual noise con-
secutively.

The preset channel cannot be re-
called.

Possible cause

The unit is placed near the TV or
computer.

The aerial direction is not placed

properly.

Did you erase the programmed sta-

tion?

Remedy

When the unit receives a radio
broadcast near a TV set, a com-
puter or a word-processor,it may
pick up noise. If this hap-
pens,try to move the unit from
the place where the noise is
picked up.

Correct the aerial direction.

Preset the channel again.

Redio programming.

Radio reception

Symptom

The remote control does not func-
tion or does not operate properly.

The power cannot be turned on
from the remote control.

Possible cause

The batteries (polarity) are not in-
serted properly.

The batteries inside the remote con-
trol are dead.

The remote control is operated from
an incorrect distance or angle.

Is the AC power lead plugged in?

Remedy

Insert properly.

Replace the batteries.

Operate it within a range of 0.2
m (8") to 6 m (20’) and within
an angle of 15

°

to either side of

centre.

Connect the AC power lead.

Remote control

CD Playback

Symptom

Even though a disc has been
loaded, “NO DISC” or “ERR” is dis-
played.

Playback stops in the middle of a
track, or playback is not performed
properly.

Playback sounds are skipped.

Possible cause

The disc is loaded up-side down.

The disc is very dirty.

The disc which does not satisfy the
standards.

Is the unit located near excessive
vibrations?

Has condensation formed inside the
unit?

Remedy

Load the disc with the correct
side up.

Clean the disc.

Load the correct disc.

Place the unit on a firm, level

surface free from vibration.

Remove the disc and leave the

power tur ned on. The unit
should function properly in
about 1 hour.

Advertising