Important safety instructions – Sony BRAVIA DMX-NV1 User Manual

Page 4

Advertising
background image

4

Important
Safety
Instructions

1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this receiver near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in

accordance with the manufacturer’s instructions.

8) Do not install near any heat sources such as radiators,

heat registers, stoves, or other receiver (including
amplifiers) that produce heat.

9) Do not defeat the safety purpose of the polarized or

grounding-type plug. A polarized plug has two blades
with one wider than the other. A grounding type plug
has two blades and a third grounding prong. The wide
blade or the third prong are provided for your safety.
If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete
outlet.

10) Protect the power cord from being walked on or

pinched particularly at plugs, convenience
receptacles, and the point where they exit from the
receiver.

11) Only use attachments/accessories specified by the

manufacturer.

12) Use only with the cart, stand, tripod, bracket, or table

specified by the manufacturer, or sold with the
receiver. When a cart is used, use caution when
moving the cart/receiver combination to avoid injury
from tip-over.

13) Unplug this receiver during lightning storms or when

unused for long periods of time.

14) Refer all servicing to qualified service personnel.

Servicing is required when the receiver has been
damaged in any way, such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the receiver, the receiver has been
exposed to rain or moisture, does not operate
normally, or has been dropped.

USE

AC power cord and other cables

If you damage the AC power cord or other cables, it may result in a fire or
an electric shock. If the AC power cord or other cables is damaged, stop
using it at once and contact the Sony service center.

s

Do not place the receiver where the power cord and cables are
subject to wear or abuse.

s

Do not pinch, bend, or twist the cord excessively. The core lines may
be bared and cut, and cause a short-circuit, resulting in a fire or an
electric shock.

s

Do not convert or damage the power cord and cables.

s

Do not allow anything to rest on or roll over the power cord and
cables.

s

Do not pull the power cord and cables.

s

Do not move the receiver with the power cord and cables plugged in.

s

Keep the power cord and cables away from heat sources.

s

Be sure to grasp the plug when disconnecting the power cord and
cables.

Wall outlet

Do not use a poor fitting outlet.
Insert the plug fully into the outlet. If it is loose, it may
cause arcing and result in a fire.
Contact your electrician to have the outlet changed.

Cable wiring

For your safety, unplug the AC power cord when wiring cables.

Take care not to catch your feet on the cables. It may damage the receiver.

Electric shock

Do not touch the AC power cord or the receiver with
a wet hand. If you plug/unplug the AC power cord
from the receiver with a wet hand, it may cause
electric shock.

Lightning

For added protection for this receiver during a lightning storm, or when it
is left unattended and unused for long periods of time, unplug it from the
wall outlet. This will prevent damage to the receiver due to lightning and
power line surges.

Small accessories

Keep small accessories out of children's reach.

CLEANING

s

Clean the AC power plug regularly.

s

If the plug is covered with dust and it picks
up moisture, its insulation may deteriorate
and result in a fire.

s

Unplug the AC power cord when cleaning
this receiver. If not, it may result in electric
shock.

s

Clean the casing of the receiver with a dry
soft cloth. Stubborn stains may be removed
with a cloth slightly moistened with a solution of mild soap and
warm water. Never use strong solvents such as thinner or benzine
for cleaning.

s

If using a chemically pretreated cloth, please follow the instruction
provided on the package.

s

Dust the ventilation holes with a dry cloth.

Advertising
This manual is related to the following products: