Samsung WB500 - Manual (Page 52)

051
Command Lever
You can enable the desired features for
the command lever on the back of the
camera.
- [Command Lever] Sub menus:
[EV], [EV(A, S)], [ISO], [WB].
- Move the command lever to the left
or right to select the submenu for each
feature.
Ú For detailed information on using the command lever, refer to Page 30.
z The [Command Lever] feature is enabled in [Program], [Manual],
[DUAL IS], or [Movie] mode.
z Selectable sub-menu and default value can vary depending on
recording mode.
Flash Intensity
You can control À ash intensity.
(You can set À ash intensity within the
range of +/- 1EV in intervals of 0.5EV.)
- [Flash EVC] Sub menus:
[+1.0], [+0.5], [0], [-0.5], [-1.0].
z In [Auto], [DUAL IS], [Beauty Shot], [Nightscene], [Scene], or
[Movie] mode, the [Flash EVC] feature is disabled.
z If the subject is too close or the sensitivity is too high, changing
the value to a negative value (-) may not have any effect.
z If the À ash intensity is out of the control range because the
exposure value is too high or low, the camera may not operate
properly.
RECORDING
Command Lever
Flash EVC
Quality
ACB
OIS
Voice Memo
Back Set OK
+1.0
+0.5
0
-0.5
-1.0
RECORDING
Command Lever
Flash EVC
Quality
ACB
OIS
Voice Memo
Back Set
EV
ISO
WB
2008/12/01 PM 01:00 2008/12/01 PM 01:00
1 1