Sony UP-D897 - Manual (Page 11)

Op
erat
io
n
Adjustments and Settings Using the Menu
11
a) The printing direction is as follows.
b) These items can also be set on the printer driver side.
When you place a check mark in a checkbox on the
“Settings” tab of the printer driver, the settings made
on the printer side are enabled. When “CO:895” is
selected in “COMD,” these items are not displayed
and can not be set. When “CO:897” is selected, these
items are disabled since the computer sends the print
command to the printer until the printer completes
printing.
c) The print direction of the images printed is as follows.
Basic Menu Operations
This section describes the basic menu operation which
are common to each menu, taking “How to set the
printing direction” as an example.
1
Press the power ON/OFF switch to ON to turn the
unit on.
RSIZE b) To select whether
or not the image
is enlarged [RS:OFF]: Prints the image
at the original size.
RS:ON: Prints the image at
a larger size, according to
the paper size set by the
printer driver.
BACK: Cancels the setting
change and returns to the
item selection column.
SAVE To register up to
three kinds of
settings SA:3: Registers the menu
settings as No.3.
SA:2: Registers the menu
settings as No.2.
[SA:1]: Registers the menu
settings as No.1.
BACK: Cancels the setting
change and returns to the
item selection column.
SHARP
b)
To adjust the
sharpness of the
printout You can set the sharpness to
any of 15 steps, from 0 to
14.
At a setting of 0, the outline
of the printout is not
emphasized.
A setting of step 2 is the
factory setting.
BACK: Cancels the setting
change and returns to the
item selection column.
SIDE c) To select the
direction in which
the image is to be
printed S:SIDE: Prints the image
rotated by 90 degrees
counterclockwise.
[S:STD]: Prints the image in
the same direction as that
displayed on the monitor.
BACK: Cancels the setting
change and returns to the
item selection column.
SPEED
(When
“ME:HD” is
selected in
“MEDIA,”
the printing
speed is fixed
to “SP:NOR”
and this item
is not
displayed.) To select the
printing speed SP:NOR: Prints at the
normal speed.
[SP:HI]: Prints at high
speed.
BACK: Cancels the setting
change and returns to the
item selection column.
Note
When “SP:HI” is selected,
the power consumption is a
little higher, compared with
printing at the normal
speed.
BACK To exit menu
mode Display this item and then
press the jog dial. The unit
exits the menu mode and
“READY” is displayed on
the LCD.
Item Function Settings
When DI:NOR is selected When DI: REV is selected
Image displayed on the monitor
Printouts
When S:STD is selected. When S:SIDE is selected