Sharp DX-B450P - Manual (Page 35)

User’s Guide 3-9
Operator Panel Menus
Operator Panel
Delay Out Close On/Off Off When ON, the printer will wait until the job
is completely printed and delivered to the
output tray before terminating the
connection, allowing all reverse-channel
data to be sent back to the host. This will
cause a reduction in printer throughput.
When OFF, reverse-channel data generated
after the job interpretation is discarded. No
reduction in printer throughput occurs.
Binary PS On/Off On When On, the feature allows all binary codes
to be processed by the PostScript interpreter.
When Off, special binary control codes may
be intercepted per the Format item setting.
Serial Setup Submenu
Interpreter Auto Switch
PCL
PostScript 3 Auto Switch
Format Raw
Normal
Binary Raw Configures how incoming print jobs are
scanned for special binary control codes.
RAW=no processing
Normal = “Adobe Standard Protocol” (ASP)
Binary = “Binary Control Protocol” (BCP)
When Interpreter setting is Auto Switch and
this setting is Raw, the printer will
automatically determine the control code
method, defaulting to Normal if no codes are
found.
Serial Mode RS232
RS422 RS232 Serial mode
Baud Rate 1200, 2400,
4800, 9600,
19200, 38400,
57600, 115200 9600 Serial baud rate
Data Bits 8, 7 8 Serial data bits
Stop Bits 1, 2 1 Serial stop bits
Parity None
Even
Odd None Serial parity
DTR Ready/Busy On/Off Off If On, the DTR signal will reflect the Ready/
Busy status.
DTR On1/Off1 On/Off Off If On, the DTR signal will reflect the Online/
Offline status.
DTR Error On/Off Off If On, the DTR signal will reflect the Error
status.
RTS Ready/Busy On/Off Off If On, the RTS signal will reflect the Ready/
Busy status.
Menu Item Value Default Description