Sanyo DP55441 - Manual (Page 31)

30
English
Output terminals
Digital Audio Output Audio Output
1 1
CONFIGURATIONS OF VGA TERMINALS
VGA IN (D-SUB) TERMINAL
Terminal : D-SUB15 PIN
Connect video output terminal of LCD TV to this terminal with a VGA Cable (not supplied). When connecting
Macintosh computer, the MAC Adapter (not supplied) is required.
1 Red Input 9 +5V
2 Green Input 10 NC
3 Blue Input 11 Sense 0
4 Reserved 12 DDC_SDA
5 Reserved 13 Horiz. sync.
6 GND 14 Vert. sync.
7 GND 15 DDC_SCL
8 GND
PC / HDMI SIGNAL MODES
This LCD TV can correspond to the signals below. After connecting with the computer, the TV can automatically
recognize the signal from the connected PC (computer) / HDMI.
PC SIGNAL MODE COLUMN (recommended)®
SYSTEM MODE Resolution V-Freq.(Hz) H-Freq.(KHz) PIXELS CLOCK (MHz)
VGA 640x480 59.94 31.47 25.18
SVGA 800x600 60 37.88 40
XGA 1024x768 60 48.36 65
WXGA 1360x768 60 47.712 85.5
WXGA 1280x768 60 47.78 79.5
SXGA 1280x1024 60 63.981 108
NOTE:
■ In principle, the TV can not display signal modes not described in the above column. However, it can sometimes
display a signal very similar with one of the modes described.
■ It is not the trouble of the TV if interference appears on the picture while switching the signal mode.
■ The Dot Clock of the computer’s signal must be less than 108 MHz.
■ When the input signal from PC is out of the PC signal mode column, above, “No Support” caution message will
display. But in some case, the LCD TV will still display the PC signal though the signal mode doesn’t exist on the
list above. Under this condition, the display position may not correct and the quality may not be admitted also.
When input signal is digital from HDMI terminal, refer to the chart below.
SYSTEM MODE Resolution V-Freq.(Hz) H-Freq.(KHz) PIXELS CLOCK (MHz)
480I 720(1440)x480 59.94 15.73 27
480P 720x480 59.94 31.47 27
720P/60 1280x720 60 45 74.25
1080I/60 1920x1080 60 33.75 74.25
1080P/24 1920x1080 24 27 74.25
1080P/60 1920x1080 60 67.5 148.5