Sony MSW-M2100 - Manual (Page 41)

Chapter 4
Playback
Chapter 4 Playback
4-7
4-3-2 Storing a Varying Playback
Speed in Memory
To store the playback speed for DMC playback, use
the following procedure.
Note
Make sure that the TSO PLAY of setup menu item 111
is set to DIS beforehand.
1
Press the DMC EDIT button, turning it on.
Waiting for the on-air cue
before starting DMC
playback
On-air start point Preroll point Speed variation start point Speed variation end point On-air end point
Stop Press the CUE/PLAY button.
Press the CUE/PLAY button
again at the on-air cue.
Normal speed
playback
DMC playback
Normal speed playback
Stop
Starting DMC playback
immediately after preroll
Normal speed
playback
DMC playback Normal speed playback
Press the LEARN button.
Z
2 5 1,4 7 3 3,4,6
4-3-1 Overview
DMC playback allows you to vary the playback speed
for a certain section of a tape, in variable speed mode
(from –1 to +3 times normal speed for digital Betacam
playback, from –1 to +3 times normal speed for MPEG
IMX playback, from –1 to +2 times normal speed for
Betacam SX playback, or from –1 to +3 times normal
speed for analog Betacam playback), and store the
varying speed in memory for later playback at the
same varying speed. For example, during a live broadcast of a sporting
event you can set the start and end points of highlights
and then provide immediate DMC playback of those
highlights.
During DMC playback the tape moves as shown in the
following figure.
(Continued)
4-3 Dynamic Motion Control (DMC) Playback
This section describes dynamic motion control (DMC)
playback.