SUPER MICRO Computer AS1011M-T2 - Manual (Page 42)

5-8
AS1011M-T2 User's Manual
Figure 5-4. Side and Top Views of DDR Installation
To Install:
Insert module vertically
and press down until it
snaps into place. The
release tabs should
close - if they do not
you should close them
yourself.
To Remove:
Use your thumbs to
gently push each re-
lease tab outward to
release the DIMM from
the slot.
Note: Notch
should align
with its
receptive point
on the slot
Notch Notch
Release
Tab
Release
Tab
Note the notch in the slot and on the bottom of the DIMM.
These prevent the DIMM from being installed incorrectly.
Support
The H8SMi-2 supports single or dual-channel, DDR2-800/667/533 unbuffered
ECC/non-ECC SDRAM.
Both interleaved and non-interleaved memory are supported, so you may populate
any number of DIMM slots (see note on previous page).
Populating two adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory. The best practice is to install DIMMS in order from 1A to 2B.
Maximum memory: 8 GB of DDR2-800/667/533 unbuffered ECC/non-ECC
SDRAM.