SUPER MICRO Computer AS1011M-T2 - Manual (Page 85)

Chapter 7: BIOS
7-15
Redirection After BIOS POST
Options are Disable (no redirection after BIOS POST), Boot Loader (redirection
during POST and during boot loader) and Always (redirection always active).
Note that some OS's may not work with this set to Always.
Terminal Type
Selects the type of the target terminal. Options are ANSI, VT100 and VT-
UTF8.
VT-UTF8 Combo Key Support
Allows you to Enable or Disable VT-UTF8 combination key support for ANSI/
VT100 terminals.
Sredir Memory Display Delay
Use this setting to set the delay in seconds to display memory information. Op-
tions are No Delay, 1 sec, 2 secs and 4 secs.
System Health Monitor
CPU Overheat Temperature
Use the "+" and "-" keys to set the CPU temperature threshold to between 65 o
and 90 o C. When this threshold is exceeded, the overheat LED on the chas-
sis will light up and an alarm will sound. The LED and alarm will turn off once
the CPU temperature has dropped to 5 degrees below the threshold set. The
default setting is 72 o C.
Fan Speed Control Modes
This feature allows the user to determine how the system will control the speed
of the onboard fans. Select "Workstation" if your system is used as a Worksta-
tion. Select "Server" if your system is used as a Server. Select "Disable" to
disable the fan speed control function to allow the onboard fans to continuously
run at full speed (12V). The options are 1) Disable (Full Speed), 2) Server
Mode 3) Workstation Mode.
Below this setting the current fan speeds are displayed.