Sanyo PDP-42XR9DA - Manual (Page 17)

Basic Operations
(Continued)
14
With the power on, press the Power button on the remote control to turn off the unit, and put the unit in standby mode. To
cut off the power completely, press the Power Switch directly.
Turning On
Insert the power cord into the wall outlet. Press the Power Switch on the unit to power on.
If the unit is in standby mode, press SOURCE on the unit or Power button on the remote control to turn on the unit, and
you will be ready to use its features.
Turning Off
Turning On/Off the Power
Installation Guide
Exit Exit
Language English
Start OK
Auto Tuning
Country Selection Australia
Cancel Start
First Time Setup
1
3
Make sure that:
Press 3 or4 to select Standard/Energy Save or
Store/Dynamic. Press OK to confirm the selection.
The first time you use the TV, you need to set up the TV.
!
You have installed the batteries in the remote control.
!
You have connected the TV to an antenna or cable TV outlet.
!
You have connected the power cord.
2
Press POWER to turn on the TV. After a few seconds
the Energy Save Mode screen opens.
4
Now the Installation Guide screen will display.
Highlight Auto Tuning item, and press OK to access.
Installation Guide
Exit Exit
Language English
Start OK
Auto Tuning
5
Press 3 or4 to highlight Start item, and then Press OK to
begin the auto channel search.
= The Language and Country Selection items is defaulted and cannot be adjusted.
Note
Navigate
To use this TV for displaying in a store,
please select [Store/Dynamic].
[Standard/Energy Save] mode is recommended
for normal home use.
Energy Save Mode
Store/Dynamic Standard/Energy Save
Confirm OK