Star Trac IP-S6331 - Manual (Page 4)

Page 4
2. Grip the top of the outside SHROUD and lift
to remove it from the weight stack.
Carefully store the SHROUD for later use.
Now repeat with the inside SHROUD.
REMOVE THE SHROUDS:
1. Using a 4MM hex key remove the
(M6,30MM,Button Head Bolt) from the
rear of the weight stack. Save this bolt
as you will need it to re-install later. After
the bolt has been removed rotate the
black TOP BUMPER towards the front of
the weight stack then lift it off and set
aside.
REMOVE FROM PALLET:
1. With the shrouds removed, locate and
remove the two bolts that secure the
equipment to the pallet. There will also be
a bolt through each of the equipment’s
feet.
2. Once all bolts fastening the equipment to
the pallet have been removed, carefully
remove equipment off of the pallet and
place in desired location.
PROTECTIVE FEET:
1. Your equipment shipped with a set of
PROTECTIVE FEET. Tilt the equipment
towards the weight stack until the two
smaller feet lift off the ground; slip the
PROTECTIVE FEET on and set the
equipment back down.
2. Now tilt the equipment onto the two
small feet lifting the weight stack off the
ground. Install the large PROTECTIVE
FOOT and set the equipment back
down.