Star Trac IP-S6331 User Manual
Page 6
Page 6
INSTALLING THE ARM PIVOT (CAM SIDE):
1.
Install the CAM/SHAFT assembly thru the
bearings in the ARM PIVOT BRACKET
and into the ARM PIVOT.
2.
Install END CAP as shown with a M8
Washer and (M8, 20MM, Socket Head
Screw). NOTE: Place the END CAP with
the red rotational sticker toward the user.
3.
Align the thru holes in the ARM PIVOT
with the threaded holes in the
CAM/SHAFT and screw in two (M8,
25MM, Socket Head Screw). Tighten
using a 4MM hex key.
Arm
Pivot
Arm Pivot
Bracket
Cam / Shaft
Assembly
Spacer w/
25mm ID
ATTACHING THE CABLE:
1.
Locate the loose cable end and loop
around the pulleys as shown taking
care not to fray the stranded wire.
2.
Pull and insert the CABLE END into
the CABLE MOUNT of the CAM until the
end of the CABLE is visible in the sight
hole.
3.
Secure with the four sets screws (M8)
included, using a 4MM hex key. Torque
to 15-17 N-m.
Sight Hole
INSTALLING THE SEAT BOTTOM:
1.
Align and install the ADJUSTABLE
SEAT using four (M8,16MM,Socket
Head Bolts) and four (M8,Washers)
Tighten using a 6MM hex key.
2.
Pull up on the red handle and verify that
the seat assembly slides up and down
smoothly.