Automatic rearming, Valet mode, Driver calling/page feature – ScyTek Electronics PRECISION 5500 User Manual
Page 16
Page 12 - Precision
To set the Emergency Override Code:
1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
· The siren will provide one long chirp, indicating that you have entered Programming.
3. Press the valet switch 4 times.
· The siren will chirp each time the valet switch is pressed.
4. Within 5 seconds, press Button 3 on the transmitter.
· The siren will chirp 3 times.
5. Press the valet switch the number of time equal to the desired code (from 1-15).
6. Turn off the ignition then arm the system.
7. Disarm the system using the new Override Code to permanently store the new code.
Note: If the code set procedure is not properly performed, turn off the ignition and begin again. The override code will not
be permanently stored until the code is used to disarm the system.
* Automatic Rearming
The Automatic Rearming feature is designed to protect the vehicle in the event the system is accidentally
disarmed. With the Automatic Rearming feature enabled, the alarm will automatically rearm and lock 30
seconds after disarming. Automatic Rearming feature will be temporarily bypassed until the next arming
cycle if the ignition is turned on.
Valet Mode
The Valet Mode temporarily disables the Security* and/or Remote Start System so the vehicle may be
operated by a mechanic or parking attendant.
To activate the Valet Mode:
1. Turn on the ignition.
2. Press and hold the override switch for 5 seconds.
· The siren*/horn will chirp/honk once and the LED light will stay ON to confirm the Valet Mode
is on.
3 Repeat steps 1 and 2 to deactivate Valet Mode
· The siren*/horn will chirp/honk twice and the LED light will turn off to confirm the Valet Mode
is off.
3. Turn off the ignition.
While in Valet Mode the remote transmitters will continue to lock and unlock the doors, and operate the
optional auxiliary functions.
DRIVER CALLING/PAGE FEATURE
The Presicion 5500 and 2200 Series is equipped with a driver calling or paging feature that allows the
system to send a page to the LCD transmitter in the event the transmitter has been misplaced or lost
(within 1500 feet)
To activate the DRIVER CALLING/PAGE feature:
1.Locate the Call/ Valet/ Emergency override button in your vehicle (Ask your installation shop)
· With the ignition switch OFF, press and hold the Call/ Valet/ Emergency override button for 2
seconds, then release.
· The LCD transmitter will beep continually and the “DRIVER CALLING” icon will appear
· Press and release button 5 to turn off transmitter page.