Sony Blu-ray Disc/DVD Player BDP-S390 - Manual (Page 33)

33
Additional Informati
o
n
You cannot connect the player to the
wireless LAN router.
, Check if the wireless LAN router is on.
, Depending on the surrounding
environment, such as the wall material,
radio wave receiving condition, or
obstacles between the player and the
wireless LAN router, the
communication distance may be
shortened. Move the player and the
wireless LAN router closer to each
other.
, Devices that use a 2.4 GHz frequency
band, such as a microwave, Bluetooth,
or digital cordless device, may
interrupt the communication. Move
the player away from such devices, or
turn off such devices.
The desired wireless router do not
appear in the wireless network list.
, Press RETURN to return to the
previous screen, and try wireless setup
again. If the desired wireless router is
still not detected, press RETURN to
select [Manual registration].
The message [A new software version
is available. Please go to the “Setup”
section of the menu and select
“Network update” to perform the
update.] appears on the screen when
turning the player on.
, See [Network Update] (page 25) to
update the player to a newer software
version.
You cannot start the PARTY
STREAMING function.
, Check that [PARTY Auto Start] is set
to [On] in [Network Settings]
(page 30).
The [Control for HDMI] function does
not work (BRAVIA Sync).
, Check that [Control for HDMI] is set
to [On] (page 28).
, If you change the HDMI connection,
turn the player off and on again.
, If power failure occurs, set [Control
for HDMI] to [Off], then set [Control
for HDMI] to [On] (page 28).
, Check the following and refer to the
instruction manual supplied with the
component.
– the connected component is
compatible with the [Control for
HDMI] function.
– the connected component’s setting
for the [Control for HDMI] function
is correct.
, When you connect the player to a TV
through an AV amplifier (receiver),
– if the AV amplifier (receiver) is not
compatible with the [Control for
HDMI] function, you may be unable
to control the TV from the player.
– if you change the HDMI
connection, disconnect and
reconnect the AC power cord, or a
power failure occurs, try the
following:
1 Switch the input
selector of the AV amplifier
(receiver) so that the picture from
the player appears on the TV screen.
2 Set [Control for HDMI] to [Off],
then set [Control for HDMI] to [On]
(page 28). Refer to the instruction
manual supplied with the AV
amplifier (receiver).
Control for HDMI (BRAVIA
Sync)