Sharp UX-465L - Manual (Page 37)

Setting Up and Using OpenLCR
35
2. S
e
tting Up
O
penLCR
LCR TABLE SELECT
1=02MIN, 2=04MIN
Your fax needs to
know whether the call
will be long or short to
route it for the best
rate.
1
Press these keys:
FUNCTION
2
Press 1 to select the SHORT TIME
setting, or 2 to select the LONG
TIME setting.
1 2 or
SHORT LONG
Note: If the display shows TABLE
NOT EXIST, you must first download
the rate data.
Selecting a long or short call
Before you make a long distance or
international phone/fax call, select
whether the call will be a long call or a
short call.
OpenLCR
•
The initial SHORT TIME setting is 2
minutes, and the initial LONG TIME
setting is 4 minutes. If desired, you
can change these settings as
explained on the following page.
•
The short/long time selection will
remain in effect for all calls until you
change it.
Changing the SHORT TIME
and LONG TIME settings
The initial SHORT TIME setting is 2
minutes, and the initial LONG TIME
setting is 4 minutes. If the typical
durations of your short and long calls
are different, you should change the
time settings to ensure that OpenLCR
routes your calls for the best rate.
♦
For example, if your fax
transmissions normally last about 3
minutes and your phone calls last
about 5 minutes, set 03 for the
SHORT TIME and 05 for the LONG
TIME. Before sending a fax, select
the SHORT TIME setting (03MIN)
in the procedure on the preceding
page. Before making a phone call,
select the LONG TIME setting
(05MIN).
♦
When you change the SHORT
TIME and/or LONG TIME setting,
the fax machine will automatically
call OpenLCR and receive rate data
for the new times.
1
Press these keys:
7
FUNCTION
Press
twice
LCR TIME SELECT
PRESS START KEY