Sony 798 MHz to 822 MHz - Manual (Page 42)

Specifications
DIGITAL VTRs
DSR-2000P / DSR-1800P / DSR-1600P / DSR-1500AP
Editing Recorders / Players
DSR-2000P DSR-1800P DSR-1600P DSR-1500AP
General
Power requirements AC 100 V to 240 V, 50/60 Hz
Power consumption (Max. ) 110 W 100 W 70 W 60 W
Operating temperature 5 °C to 40 °C (41 °F to 104 °F)
Storage temperature -20 °C to 60 °C (-4 °F to 140 °F)
Operating humidity Less than 80%
Storage humidity Less than 90%
Tape speed 28.221 mm/s
Recording/Playback time Standard size: 184 min. with PDV-184ME/184N/184MEM Mini size: 40 min. with PDVM-40ME/40N/40MEM
Fast forward/Rewind time Standard size: Less than 3 min. with PDV-184ME/184N/184MEM Mini size: Less than 1 min. with PDVM-40ME/40N/40MEM
Search speed Shuttle mode: Shuttle mode: still to ±60 times normal speed
still to ±60 times normal speed Digital slow mode: ±0.5 times normal speed
Digital slow mode:
±1 times normal speed
Mass 18 kg (39 lb 10 oz) 13 kg (28 lb 10 oz) 6 kg (13 lb 3 oz)
Dimensions 427 x 175 x 496.5 mm 427 x 174 x 400 mm 210 x 130 x 420 mm
(W x H x D, excluding projections) (16 7/8 x 7 x 19 5/8 inches) (16 7/8 x 6 7/8 x 15 3/4 inches) (8 3/8 x 5 1/8 x 16 5/8 inches)
Video Performance
Bandwidth Luminance 25 Hz to 5.0 MHz +1.0/-2.0 dB 25 Hz to 5.0 MHz ±1.0 dB 25 Hz to 5.0 MHz +1.0/-1.5 dB
(via analogue 5.75 MHz +0/-3.0 dB
component I/O) (Typical measurement)
Chrominance 25 Hz to 2.0 MHz + 1.0/-2.0 dB
S/N ratio (via analogue component I/O) More than 55 dB
K-factor (K2T, KPB) Less than 2.0%
Y/C delay 0 Less than 30 ns
Audio Performance
Frequency response
2 CH mode (48 kHz/16-bit) 20 Hz to 20 kHz +0.5/-1.0 dB 20 Hz to 20 kHz ±1.0 dB
4 CH mode (32 kHz/12-bit) 20 Hz to 14.5 kHz +0.5/-1.0 dB 20 Hz to 14.5 kHz ±1.0 dB
Dynamic range More than 90 dB More than 87 dB
Distortion (THD+N) Less than 0.05% Less than 0.07%
Video Signal Inputs
Analogue
Ref. Video
Composite, 1.0 Vp-p, 75 Ω , 0.3 Vp-p, 75 Ω , sync negative — Composite, 1.0 Vp-p, 75 Ω ,
(BNC x2, loop-through connection) sync negative sync negative
Video (BNC x2, loop-through connection)* 1 Composite, 1.0 Vp-p, 75 Ω , sync negative — Composite, 1.0 Vp-p, 75 Ω , sync negative
Component Y 1.0 Vp-p, 75 Ω , sync negative — 1.0 Vp-p, 75 Ω , sync negative
(BNC x3) * 1 R-Y 0.7 Vp-p, 75 Ω (100 %) — 0.7 Vp-p, 75 Ω (100 %)
B-Y 0.7 Vp-p, 75 Ω (100 %) — 0.7 Vp-p, 75 Ω (100 %)
S-Video * 1 DIN 4-pin x 1 — BNC x 2
Y: 1.0 Vp-p, 75 Ω , sync negative Y: 1.0 Vp-p, 75 Ω , sync negative
C: 0.3 Vp-p, 75 Ω (at burst level) C: 0.3 Vp-p, 75 Ω (at burst level)
Digital
SDI *
2 * 3 BNC x 2, active-through connection — BNC x 1
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656 Conforms to Serial Digital Interface
(270 Mb/s), ITU-RBT.656
SDTI (QSDI) (BNC x1) * 3 * 4 Conforms to SDTI (270 Mb/s), SMPTE 305M/322M — Conforms to SDTI (270 Mb/s),
SMPTE 305M/322M
i.LINK (DV In/Out) (6-pin x1)* 5 * 6 * 7 IEEE1394-based — IEEE1394-based
Audio Signal Inputs
Analogue
Audio *
1 XLR 3-pin female x4 — XLR 3-pin female x2
-6/0/+4 dBu, 600 Ω on/off/ -6/-3/0/+4 dBu, 600 Ω on/off/ — -6/-3/0/+4 dBu,
-60 dBu, high impedance -60 dBu, high impedance high impedance
Digital
AES/EBU *
2 * 3 BNC x 2 — BNC x 2
75 Ω , unbalanced 75 Ω , unbalanced
Video Signal Outputs
Analogue
Ref. Video (BNC x1)
0.3 Vp-p, 75 Ω , sync negative —
Video Video 1/2/3 (super) BNC x 3 Video 1/2(super) BNC x 2 Video 1/2/3 (super) BNC x 3
Composite, 1.0 Vp-p, 75 Ω , sync negative
Component (BNC x3) Y: 1.0 Vp-p, 75 Ω , sync negative R-Y: 0.7 Vp-p, 75 Ω (100%) B-Y: 0.7 Vp-p, 75 Ω (100%)
S-Video DIN 4-pin x 1 BNC x 2
Y: 1.0 Vp-p, 75 Ω , sync negative C: 0.3 Vp-p, 75 Ω (at burst level)
Digital
SDI *
2 * 3 * 8 BNC x 3 BNC x 2
Conforms to Serial Digital Interface (270 Mb/s), ITU-R BT.656
SDTI (QSDI) * 3 * 4 * 9 BNC x 1 BNC x 2
Conforms to SDTI (270 Mb/s), SMPTE 305M/322M
i.LINK (DV In/Out) (6-pin x1) * 5 * 6 * 7 IEEE1394-based
Audio Signal Outputs
Analogue
Audio
XLR 3-pin male x4 XLR 3-pin male x2
-6/0/+4 dBu (selectable by menu) -6/-3/0/+4 dBu (selectable by menu)
Monitor Phono x 1 RCA x1
-11 dBu, 47 kΩ , unbalanced -9 dBu, 47 kΩ , -∞ to +1 dBu, 47 kΩ ,
(-18 dBFS) unbalanced (-18 dBFS) unbalanced (-20 dBFS)
Headphone -∞to -13 dBu, 8 Ω , -∞to -11 dBu, 8 Ω , -∞to -13 dBu, 8 Ω ,
(JM-60 headphone jack x1) unbalanced (-18 dBFS) unbalanced (-18 dBFS) unbalanced (-20 dBFS)
Digital
AES/EBU *
2 * 3 * 9 BNC x 2 75 Ω , unbalanced
Time Code Input/Output
In (BNC x1) 0.5 Vp-p to 18 Vp-p, 3 kΩ , unbalanced
Out (BNC x1) 2.2 Vp-p, 75 Ω , unbalanced
Remote
RS-422A: D-sub 9-pin female x2 RS-422A: D-sub 9-pin female x1 RS-422A: D-sub 9-pin female x1
Video Control: D-sub 15-pin male x1 Video Control: D-sub 15-pin male x1 Control S (SIRCS): Stereo mini jack x1
Control Panel: D-sub 15-pin female x1 Control S (SIRCS): Stereo mini jack x1
Supplied Accessories
AC Power Cord AC Power Cord
RCC-5G 9-pin Remote Control Cable Operating Instructions
Operating Instructions
*1 The optional DSBK-1504 is required for the DSR-1500AP
*2 The optional DSBK1801 is required for the DSR-1800P
*3 The optional DSBK1501 is required for the DSR-1500AP *4 The optional DSBK1802 is required for the DSR-1800P
*5 The optional DSBK-190 is required for the DSR-2000P
*6 The optional DSBK1803 is required for the DSR-1800P/1600P *7 The optional DSBK1503 is required for the DSR-1500AP
*8 The optional DSBK-1601 is required for the DSR-1600P
*9 The optional DSBK-1602 is required for the DSR-1600P
42