Samsung SIR-TS360 - Manual (Page 44)

44
CHAPTER 3
Setting up and connecting
3 3
Testing the Signal Strength
The DIRECTV HD Receiver shall have a matrix that shows the signal strength of all
transponders per orbital position in one table. This matrix is in addition to showing the
signal strength of each active transponder individually in the system setup menu.
To start the Signal Strength test, follow these steps:
1 Press the MENU button on your remote control.
2 Highlight the SETUP menu item, then press the SELECT button.
3 Highlight the System menu item, then press the SELECT button.
4 Highlight the Signal Strength Test Matrix item, then press
the SELECT button. The Signal Strength Test Matrix screen
appears. The test will begin as soon as the screen appears.
Results are displayed in a moment.
NOTE
Transponders that are inactive shall have “n/a” in place of a signal strength number.
5 When you have finished the system test, you can run the test again using the on-screen
Test Again button, exit the Menu system by pressing the EXIT button on your remote control,
or use the arrow keys to highlight on-screen BACK button, then press the SELECT button to
return to the System menu.
SIR-TS360-CHAPTER 3 11/18/03 9:42 AM Page 44