Sharp MX-B201D - Manual (Page 95)

TROUBLESHOOTING AND MAINTENANCE
94
A Notice Page
(NP-001) has
been printed, but
the print data has
not been printed
completely.
A print job containing more data than can be held
in the print memory is sent to the machine.
→ Disable the ROPM function on the "Configuration"
tab of the printer driver setup screen. If you need
to use the ROPM function, divide the pages of the
print data into two or more print jobs.
→ The memory allocated to the printer function can
be changed in the user program "MEM. FOR
PRINTER".
76
Printing is slow.
Simultaneous use of two or more application
software programs.
→ Start printing after quitting all unused application
software programs.
–
The printed
image is light and
uneven.
The paper is loaded so that printing takes place
on the rear side of the paper.
→ Some paper types have a front and rear side. If
the paper is loaded so that printing takes place on
the rear side, toner will not adhere well to the
paper and a good image will not be obtained.
12
The printed
image is dirty.
You are using paper that is outside the specified
size and weight range.
→ Use copy paper within the specified range.
11
Paper curled or damp.
→ Do not use curled or crimped paper. Replace with
dry copy paper. During periods when the machine
is not used for a long time, remove the paper from
the tray and store it in a dark place in a bag to
prevent moisture absorption.
–
You did not set sufficient margins in the paper
settings of your application.
→ The top and bottom of the paper may be dirty if
the margins are set outside of the specified print
quality area.
→ Set the margins in the software application within
the specified print quality area.
–
Problem Cause and solution Page