Sharp XG-NV4SU - Manual (Page 33)

Appendix
E-32
Transporting the Projector
When transporting the projector, carry it by the carrying handle on the side of the projector. A soft-side carrying
bag is also provided to transport the projector.
Using the Carrying Handle
Using the Carrying Bag
CAUTION
• Always put on the lens cap to prevent damage to the lens
when transporting the projector.
• Do not lift or carry the projector by the lens or the lens
cap as this may damage the lens.
Before placing the projector into the carrying bag, set up
the inner pad inside the bag as shown.
CAUTION
• The supplied carrying bag is made exclusively for the
projector and its supplied accessories. Do not place
other items into the carrying bag with the projector or use
the bag to transport items other than the projector and its
accessories.
• This bag is provided merely to transport the projector and
its accessories, not to protect these products from
damage as a result of rough handling. Do not expose
these products to shocks or impact when transported in
the carrying bag.
• Wait until the projector has sufficiently cooled before
placing it into the carrying bag. If the projector is placed
into the bag while it is still hot, the heat may damage the
bag lining.
Carrying bag
Carrying handle
1 Take the shoulder strap
out. 2 Fasten the shoulder strap to the carrying bag.
The shoulder strap is stored in
the pocket located in front of
the carrying bag.
Attaching the shoulder strap to the carrying bag
2 1 / 2
Љ (6 cm)
The strap should extend at
least 2
1 ⁄ 2
Љ (6 cm) from the
buckle.
Follow the same procedure for the other end of the strap.
Projector
Inner pad
XG-NV4SU (E)-f 98.10.19, 5:43 PM 32