Sony 3-300-703-11(2) - Manual (Page 46)

46 GB
A stereo FM program cannot be
received in stereo.
• Press FM MODE on the remote
repeatedly until “MONO” disappears
from the display.
Optional components
There is no sound.
• Refer to General item “There is no
sound.” (page 41) and check the
condition of the system.
• Connect the component properly
(page 13) while checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all
the way.
• Turn on the connected component.
• Refer to the operating instructions
supplied with the connected component
and start playing.
To reset the system to factory
settings
If the system still does not operate
properly after performing the above
measures or other troubles not described
above occur, reset the system as follows:
Use the buttons on the unit for the
operation.
1
Unplug the power cord.
2
Plug the power cord back in.
3
Press "/1 to turn on the system.
4
Press x, PAD I and "/1 at the
same time.
“COLD RESET” appears in the
display.
The system is reset to the factory settings.
You need to readjust all the settings you
made, such as the preset stations, clock
and timer.
Messages
One of the following messages may
appear or flash in the display during
operation.
Disc/ Timer
No Disc
There is no disc on the disc tray or you
have loaded a disc that cannot be played
back on this system.
Not in Use
You have pressed a button those operation
is not allowed or invalid at that time.
OFF TIME NG!
The on time and off time of Play Timer or
Recording Timer is the same.
Push STOP!
You have pressed PLAY MODE on the
remote during playback.
Reading
The system is reading information of the
disc. Some buttons are not available.
NO STEP
You have cleared all the steps you
programmed.
OVER
You have reached the end of the disc
while pressing M on the remote during
playback or pause.
Step Full!
You tried to program more than 25 steps.