Woodstock W1685 - Manual (Page 14)

-14-
SETUP
W1666, W1685 Dust Collectors
Outlet, Gasket, and
Separator Supports
To install the outlet and the separator supports, do
these steps:
1. MAKE SURE THE DUST COLLECTOR MOTOR IS
UNPLUGGED!
2. Place gasket on top of impeller housing body and
place the outlet on the gasket (see Figure 12).
3. Secure the outlet with eight M8-1.25 X 16 hex bolts
and flat washers. DO NOT overtighten the bolts
or the gasket will squeeze out and the outlet will
crack.
4. Place a collector support over one of the sets of
holes indicated in Figure 13, and make sure the tail
at the top is oriented towards the inside as shown in
Figure 14.
5. Secure the three collector supports in place with six
M8-1.25 X 16 hex bolts and flat washers.
The outlet directs the dust to the collector hat is sup-
ported by three separator support rods. Make sure that
you do not overtighten the bolts or the threaded holes
in the base can strip.
Figure 12. Placing the outlet on the gasket.
Figure 13. Separator support bolt locations.
Figure 14. Orientation of separator sup-
port tails.