Test run – Woodstock W1685 User Manual
Page 18
-18-
SETUP
W1666, W1685 Dust Collectors
Figure 24. Hand position for emergency
stop.
Test Run
Once assembly is complete and adjustments are done to
your satisfaction, you are ready to test run the machine.
To test run the dust collector, do these steps:
1. Make sure the paddle switch is pushed in the down
or
OFF position.
2.
Make sure all the dust collection ducting and fas-
teners are tight, and that no parts or tools will get
sucked into the dust collection intake.
3. Plug in the power cord.
4. Flip the START paddle upward and keep your finger
poised over the paddle for a quick power kill, just
in case there is a problem.
The dust collector should run smoothly, with little
or no vibration or rubbing noises.
• If you hear strange or unusual noises, or a loud
vibration exists, turn off the dust collector
and wait for all moving parts to stop. Unplug the
machine, refer to
Troubleshooting on Page 25,
and investigate and correct the problem before
further operation.
• If the source of the problem is not an easy fix,
contact our Technical Support Department
for help at (360)-734-3482 or via
tech-
DO NOT investigate problems or adjust
the dust collector while it is running.
Wait until the machine is turned off,
unplugged, and all working parts have
come to a complete stop before you
proceed!