SATO MB400 - Manual (Page 12)

MB400
Quick Guide Pg 9
Installing and Removing Battery Pack
Remove the protection case.
1. Place your finger on the battery cover ribbed
area, and open the battery cover in the
direction of the arrow.
2. Insert the battery pack with the connector
facing towards the end.
* Insert the battery all the way in until the
lock clicks into place.
3. To remove the battery pack, press down the
lock lever and release the lock. Then pull the
battery pack out placing your finger into the
notch.
** Take caution not to drop the battery pack when
removing it. The battery pack may be damaged if it
is dropped.
Battery Status
1. Battery near end
When the battery is getting low, the battery
near end is detected and the BATTERY
LED indicator lights up in orange. The keys
can still be operated, however the battery
should be recharged.
2. Low Battery Error
When the battery is empty, a low battery error is detected and the BATTERY
LED indicator lights up in red. The keys cannot be operated, and after 30 seconds
the power automatically turns off. Make sure to recharge the battery.
Status BATTERY LED indicator
Battery near end Light (orange)
Low battery error Light (red)
** The BATTERY LED indicator does not light up during printing or an error, even if
battery near end or low battery error has been detected.
MB400 Quick Guide Pg 10
Media Loading
Setting Labels
The method of setting labels may vary depending on the print mode.
[Continuous Mode]
1. Press the cover Open/Close lever in the
direction of the arrow to release the front
cover lock.
2. Slide the front cover to open. Hold the
front cover and slide it in the direction of
the arrow until it stops.
3. Open the front cover in the direction of the
arrow.