SATO MB400 - Manual (Page 4)

MB400
Quick Guide Pg 1
Table of Contents
Installation ……………………………………………………………………. 2
Installation
…………………………………………………………... 2
Other Accessories …………………………………………………… 2
Considerations ………………………………………………………. 3
Components …………………………………………………………. 4
Battery Pack ………………………………………………………………….. 7
Charging the Battery Pack …………………………………………… 7
Installing and Removing Battery Pack ………………………………. 9
Media Loading ……………………………………………………………….. 10
Setting Labels ………………………………………………………... 10
Adjusting the Position of the Label Sensor ………………………….. 13
RS232 Connection …………………………………………………………….. 14
Troubleshooting ……………………………………………………………….. 15
MB400 Specifications …………………………………………………………. 18
Options ………………………………………………………………………… 20
MB400
Quick Guide Pg 18
MB400 Specifications
Item Details
Printing Method Thermal
Head Density 8 dots/mm
Maximum Printing Size Width 104mm x Pitch 297mm
Printing Speed Max. 50mm/sec. (may vary from environment)
Printing mode Continuous, Dispense and Journal
Size Printer : W190mm x D80mm x H139mm
Weight Approximately 960g (including battery)
Power (Battery) Packet type (Lithium ion battery) : 1600mAh; Will
print 1 roll of journal paper (25m) on continuous
mode when fully charged (printing rate at 15% or
less)
Paper Always use specified labels
Label Shape Roll; Maximum outer diameter: 58mm
Label Size Width: 50-11mm (53-114mm)
Pitch (Continuous): 25-297mm (28-300mm)
Pitch (Dispense): 25-182mm (28-185mm)
Numbers indicated in ( ) are for pasteboards, non-
adhesive or non-separated labels and journal paper.
Thickness Continuous: 0.06 - 0.18mm
Dispense: 0.18mm (the thickness of the pasteboard
is under 0.06mm)
Self Diagnosing Function Battery Check / Paper end
Head Open / Test Printing / Head Check
Power Save Function In Sleep mode after 5 seconds without any
operation, and Auto Power Off mode after 5
minutes without any operation.
RS232C/TTL High density special connector Interface
Optical
Coupler IrDA (IrDA Standard Ver. 1.2 compliant)