Sharp UX-B30 User Manual

Page 66

Advertising
background image

Auto-Cordless Fax Control (answering with an extension phone in TEL mode)

62

1

Answer the extension phone when it

rings.

2

If you hear a soft fax tone, wait until your fax responds (the extension
phone will go dead), then hang up.

3

If the fax doesn't respond, or if the other party first talks to you and then

wants to send a fax, press

once and

twice on the extension

phone (only on a tone dial phone). This signals the fax to begin
reception. Hang up.

•

The above step is necessary if you have set the Fax Signal Receive setting
to NO.

•

Your fax will not accept the signal to begin reception (

) if a

document is loaded in its feeder.

Phone goes dead

Beep

Auto-Cordless Fax Control
(answering with an extension phone in TEL
mode)

Important: If a document is loaded in the machine’s feeder, remove it before
performing the steps below. (Fax reception is not possible when a document
is in the feeder.)

You can also start fax reception in TEL mode by answering any extension
phone connected to the same line as the fax machine-even a cordless phone.

all.book Page 62 Tuesday, June 1, 2004 4:24 PM

Advertising