Sony WM-EX122 User Manual

Ex122, Getting started, Playing cassette

Advertising
background image

Operating the Cassette Player

To wind the tape

Press

0 or ).

To adjust the volume

Turn the VOLUME
control.

To stop

Press

p STOP.

Notes on playing cassettes
• Do not use cassettes longer than 90 minutes except for long

continuous playback.

• If the tape is playing but no sound comes out, the batteries may be

weak. Replace all batteries with new ones.

• If your Walkman has not been used for a long time, run the

Walkman for a few minutes before inserting a cassette.

• Do not open the cassette holder while the tape is running.
• Do not wind the headphones cord around the Walkman. The

buttons may be kept pressed, causing unnecessary battery usage.

Using MEGA BASS

Set the MEGA BASS switch to ON to produce deep and
powerful sound.

When using MEGA BASS
If the AVLS switch is set to LIMIT, the MEGA BASS effect is reduced.

3-810-695-13(1)

Printed in Malaysia

Sony Corporation © 1996

Cassette Player

WM

-EX122

Operating Instructions

WALKMAN is a registered trademark of Sony Corporation.

OWNER’S RECORD

The model number is located at the rear and the
serial number is located inside the cassette holder.
Record the serial number in the space provided
below. Refer to them whenever you call upon your
Sony dealer regarding this product.

Model No. WM-EX122

Serial No.

Getting Started

Using with Batteries

Insert two AA (R6) batteries in correct polarity.

Notes
• When you are not going to use your Walkman for a long time,

remove the batteries to prevent damage from battery leakage and
corrosion.

• When the batteries become weak, the sound will be unstable or can

not be heard. In such a case, replace both batteries.

• Concerning the battery life, see “Specifications”.

Using External Power Sources

You can connect the following external power sources
through the DC IN 3 V jack located on the bottom.
(When you plug a cord into the DC IN 3 V jack, the
internal batteries are automatically bypassed.)
•House current using an AC-E30HG AC power adaptor

Note
Use only the recommended
AC-E30HG AC power adaptor (not
supplied). Do not use any other AC
power adaptor.

1

Insert a cassette.

2

Select the NORM or
CrO

2

/METAL mode to

match the tape type.

3

Press the

9 PLAY.

Playing Cassette

NORM

CrO

2

/

METAL

PLAY

2

pSTOP

VOLUME

NORM CrO

2/

METAL

0 )

9PLAY

Cassette holder

MEGA BASS

AA (R6) x 2

DC IN 3V

ON

OFF

Polarity of the plug

Advertising